Video - How do I update my Mentor ARM7 processor board?

This tutorial is normally used for Mentor updates to the processor board in the Mentor cabinet. 
Boards come blank...with no memory.  You MUST flash software on the board to make it respond as a Mentor processor.  

This applies only to 08BSPG1T and later boards.  08BSPE2T and other like it, require a Eprom for proper operation.  

This is a tutorial for updating the ARM7 processor board using the MilFlash program.  This procedure updates the CBW operations software for Mentor on the processor board.  The CBW Mentor PC software must be compatible with the processor board software for proper operation.

Note: Issues have been experienced while using USB hubs for this update procedure. It is recommended to connect the processor board directly to the PC USB port.

Updating a Mentor from Intel 186 to ARM7

The Miltrac address of a ARM7 Processor must be set on the processor board rotary switch and the software for Mentor on the PC.  But, the switches are in HEX.  So, for example, address 17 in Mentor config is Address 11 in Hex. 
;
 

Updating an ARM7 Processor Board